Enable And Configure Wireless Security Without Wps On Your Nbg-417N - ZyXEL Communications NBG-417N User Manual

5.2.2 Enable and Configure Wireless Security without WPS on your NBG-
417N
This example shows you how to configure wireless security settings with the following parameters
on your NBG-417N.
SSID
Channel
Security
Follow the steps below to configure the wireless settings on your NBG-417N.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Open the Wireless LAN > General screen in the NBG-417N's Web Configurator.
1
Make sure the Enable Wireless LAN check box is selected.
2
Enter SSID_Example3 as the SSID and select a channel.
3
Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared
4
Key field. Click Apply.
Figure 32 Tutorial: Network > Wireless LAN > General
NBG-417N User's Guide
SSID_Example3
6
WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
Chapter 5 Tutorials
Section 2.2 on page 19).
53