Adding And Attaching A Gateway - Altigen ACM 6.5 Administration Manual

Parameter
Set CT-Bus Clock
Board button
Refresh button
Config button

Adding and Attaching a Gateway

Always try to attach a gateway when call activity in the system is low. If
Caution!
resources are being used in one of the gateways, ongoing calls may be
dropped.
To attach a gateway to the MAXCS system, you must first add it to the list in the
Softswitch Component Configuration window.
To add a gateway to the list:
1. Click the Add button. The Add Gateway dialog box appears:
Description
This parameter determines which telephony
board will provide the clock signal for the TDM
bus. If you don't have multiple T1 or E1 boards
in a gateway, the default Auto setting is
recommended. The system will find the
appropriate board to supply the clock. If you
have multiple T1 or E1 boards in a gateway, the
system will automatically select the one with the
lowest logical board ID as the clock source.
However, in some circumstances, you may need
to manually change to other boards. For
example:
If multiple T1/E1 boards are in the gateway
1.
and the T1/E1 board that has been selected
automatically is not active.
If the T1/E1 board that has been selected
2.
automatically is set up as a tie trunk to
another system, and the T1/E1 connecting to
the CO is on the other board.
[Not used at this time]
Refreshes the selected gateway's (read-only)
status display
Opens the AltiGateway Configuration Tool,
where you can see information on the selected
gateway and change the gateway ID and
password for this gateway.
MAXCS ACM 6.5 Administration Manual 79
Adding and Attaching a Gateway