DNIS, Caller ID:
DTMF (Dual Tone Multi-Frequency)
•
Physical Termination:
RJ-48X or RJ-48C
•
Wire:
4 wires
•
800 Service:
You decide
•
Termination Impedance:
100 ohms
•
Type of Registered Services Provided
BN 1.544 Mbps SF without power
•
DN 1.544 Mbps SF B8ZS without power
•
1KN 1.544 Mbps ANSI ESF without power
•
1SN 1.544 Mbps ANSI ESF, B8ZS without power (recommended)
•
Service Order Code
SOC 6.0P AS.2
T1 Channel Assignment
Trunk Type—In, Out, or 2-Way (recommended)
•
Channels Assigned—24 (Enter partial channels if you wish to subscribe to both voice
•
and data service.)
Hunting—Most Idle, Least Idle, Ascend, Descend
•
DNIS Digits/Signal—3/DTMF (can be 3 to 10 digits)
•
Caller ID Signal—DTMF, if available (Not every service provider provides Caller ID
•
over T1 lines.)
CSU/DSU Requirements
The CSU (channel service unit) is a device used to connect a digital trunk line coming in
from the phone company to the PBX. A CSU can terminate signals, repeat signals and
respond to loopback commands sent from the central office.
468
MAXCS ACM 6.5 Administration Manual