Launching The Gui - Alcatel-Lucent OmniAccess 700 User Manual
Web gui release versions: 2.2; 2.2-r02; 2.3
Hide thumbs
Also See for OmniAccess 700:
- Brochure (2 pages) ,
- Getting started manual (25 pages) ,
- Cli configuration manual (1193 pages)
Table of Contents
Advertisement
Left running head:
Chapter name (automatic)
GUI Layout and Logging on to USGM
L
AUNCHING THE
Follow the procedure given below to access and configure the OA-700 system
through the USGM.
Step 1: Enable HTTP/HTTPS to access the OA-700 using HTTP/HTTPS through
a web browser after being authenticated. By default, the access is disabled.
Note:
To enable HTTP service on your system, enter the following command in the
configuration mode:
ALU (config)# http enable
To enable HTTPS service on your system, enter the following command in the
configuration mode:
ALU (config)# https enable
Step 2: Configure IP address for an interface.
Note:
To configure IP address for a given interface, follow Step 1 through Step 10 detailed in
the "Accessing OA-780/OA-740 System Through CLI" section of the OA-780/ OA-
740 Hardware Installation Guide.
Step 3: Open a web browser in your PC.
Step 4: In the address bar/field, type the IP address of the interface and press the
Enter.
This launches the USGM with the login page.
6
Beta
GUI
Alcatel-Lucent
Web GUI Users Guide
Beta
Advertisement
Table of Contents
