Figure 4-8 The Connecting Boards Before Combining Two Cabinets Side By Side; Figure 4-9 The Connecting Boards After Combining Two Cabinets Side By Side; Figure 4-10 Effect After The Installation Of Two Combined Cabinets - Sagem 4450E Hardware Installation Manual

Figure 4-8 The connecting boards before combining two cabinets side by side

Figure 4-9 The connecting boards after combining two cabinets side by side

Figure 4-10 Effect after the installation of two combined cabinets

Insulation test
1.1.1.40 1.1.1.40 1.1.1.40 1.1.1.40
Set the multimeter to the resistor range to measure the resistance between the bolt of the pressure plate
assembly and the cabinet. If the circuit is disconnected, end the installation. Otherwise, it indicates the cabinet is
not insulated from the supports. In this case, remove all the pressure plate assemblies to check if any insulation
sleeves or pads of the supports are missing or any insulation parts are damaged. Then install the pressure plate
assemblies again and repeat the insulation test.
3P@C Installation Manual
Page 4-7
Reproduction and communication in any form prohibited without the written permission of SAGEM SA
SAGEM 3P@C