Figure 3-4 Appearance Of The Cabinet Packing Box - Sagem 4450E Hardware Installation Manual

1.1.1.34 1.1.1.34 Packing box of accessories
1.1.1.34 1.1.1.34
The packing box of accessories uses a small carton. Inside it there are a User Manual, a user
registration/warranty card, an antistatic wrist strap, subscriber cables and suite of packing
materials.
Packing box of boards
1.1.1.35 1.1.1.35
1.1.1.35 1.1.1.35
The packing box of boards usually adopts a carton. Inside the packing box, there are packing
materials such as foam pad, antistatic plastic bag and desiccants. After opening the carton, wear
an antistatic wrist strap first before taking the board out of the antistatic bag.
Note
Cabinet packing box
1.1.1.36 1.1.1.36 1.1.1.36 1.1.1.36
The assembly wooden box is used as the packing box of the cabinet. It is connected and fixed with
plastic clips. Figure 3-4 shows its outside view. Inside the packing box, there are packing materials
such as foam pad, plastic bag, desiccant, cabinet, marking template and cabinet installation
instructions. The cabinet is placed in the antistatic plastic bag. Its upper edge, bottom edge and all
the corners are protected with the foam pads, and the foam pads are connected and fixed with
paper boards. Inside the cabinet there are guide rails.

Figure 3-4 Appearance of the cabinet packing box

3P@C Installation Manual
Page 3-12 Reproduction and communication in any form prohibited without the written
permission of SAGEM SA
1. If a board is moved from a place with low temperature
and low humidity to another place with high temperature and
high humidity, you have to wait at least 30 minutes before
unpacking it so as to avoid damages to the board caused by
the moisture condensed on the board surface.
2. You must wear an antistatic wrist strap before taking out
the board to avoid damage.
SAGEM 3P@C