Backuping The Configuration File - Sagem 4450E Hardware Installation Manual

Format of configuration file
Saved in the command form
Only non-default constants are saved so as to save space.
The configuration file is based on the command mode. The commands with the same
command mode are listed together. Different command modes are separated by blank lines or
remark lines (the lines starting with a "!").
End with "end of config"
To view the content of the configuration file, execute the following commands in the configuration mode:
Configuration procedure:
Step 1
Step 2
The following is a configuration file:
Configuration example:
3P@C (config)# show running-config
!3P@COS system config file
idle-timeout 0
!preconfig config
!Syslog config
config syslog lowest-level 7
config syslog type NAS enable
config syslog type RADIUS enable
config syslog type DHCPS enable
config syslog type HIPMG enable
config syslog type PPPOE enable
config syslog type PPP enable
config syslog type L3SWITCH enable
config syslog type SNTP enable
Note that the command starting with "!" is remark information.

7.2.2. Backuping the Configuration File

7.2.2. 7.2.2. 7.2.2.
After the user configures the equipment, the user is suggested to backup the configuration file. Then, the user
can download the configuration file to the equipment, or load the configuration file to the equipment with similar
configuration in case of need.
The example below instructs you how to transfer the system file. The IP address of the FTP server is
20.1.1.1, and the configuration file is renamed as config.txt after the configuration file is transferred to
the FTP server.
3P@C 4450E operation procedures:
Step 1
Step 2
3P@C Installation Manual
Page 7-13 Reproduction and communication in any form prohibited without the written permission of
SAGEM SA
show startup-config
show running-config
First enable the FTP server and set the user name and password. For
example, the user name is "ftpuser" and the password is "123".
Transfer the system configuration file, and execute the commands below in
the 3P@C 4450E equipment:
View the initial configuration of the
equipment
View the current configuration of the
equipment
SAGEM 3P@C