Command Line Edit Feature; System Management; Storage Media And File Type; Table 6-4 Line Edit Commands In The Command Line - Sagem 4450E Hardware Installation Manual

6.3.4. Command Line Edit Feature

6.3.4. 6.3.4. 6.3.4.
Table 6-4 lists the line editing commands that can be used in the command line.

Table 6-4 Line edit commands in the command line

Command
Back Space or Del or
Ctrl+h
Up arrow key, or Ctrl+p
Left arrow key or Ctrl+b
Right arrow key or Ctrl+f
Down arrow key or Ctrl+n
Ctrl+a
Ctrl+e
Ctrl+d
Ctrl+k
Ctrl+t
Ctrl+u
Ctrl+w
prompt
prompt

6.4. System Management

6.4.
6.4. 6.4.
6.4.1.

6.4.1. Storage Media and File Type

6.4.1. 6.4.1.
The 3P@COS, configuration file and other applications of 3P@C 4450E are saved in the Flash. See Table 6-5
for the related file types.
Table 6-5 Correspondence between file types and command line parameters of 3P@C
4450E
Parameter
3P@COS
config-file
adufpga|vdubfpga
3P@C Installation Manual
Page 6-6 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Function
Deletes a character to the left
Invokes the previous history command
Moves the cursor to the left by a character
Moves the cursor to the right by a character
Shows the next history command if the up arrow
key has been used previously to invoke the
previous history command
Moves the cursor to the beginning of the line
Moves the cursor to the end of the line
Deletes the character where the cursor is
Deletes all characters after the cursor
Changes the character where the cursor is with
that on the left of the cursor, and moves the
cursor to the right by a character
Deletes the whole line
Deletes all characters on the left of the cursor
Of the above commands, Del, up arrow key, down arrow
key, left arrow key and right arrow key only support the
mode of using Telnet to configure the switch, rather than
serial interface configuration. However, the Ctrl+h, Ctrl+p,
Ctrl+b, Ctrl+f and Ctrl+n commands all support the above
two login modes.
For details of the commands, see the 3P@C 4450E IP-
DSLAM Software Configuration Manual.
Description
3P@COS operating system
Configuration file
FPGA code of ADU and VDU
SAGEM 3P@C