Table of Contents
Advertisement
9.2.3. Reset
Reset of the service board needs to be implemented under the following condition:
When some unrecovered faults occur to the system, you can recover the system by resetting the
service board.
Reset method for the card:
Reset
mode
Soft reset
prompt
9.2.4. Replacing Service Board
If the system control board needs to be replaced in the system running process, you should implement the
following operation:
Steps
Step 1
Step 2
Note
Step 3
Step 4
3P@C Installation Manual
Page 9-8 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Operation
Use
the
reboot
{<0-15>}*1
command to reboot the specified
slot card.
You can implement the power-off reboot to the service
board through the hot plugging.
Operation
To confirm the slot of the replaced
service
board,
execute
command show version all or
show boardinfo.
Confirm that the service in the
service board stops, and the
service should be transferred to
other
cards
or
devices
necessary.
In the card plugging process, you must wear the anti-static
wrist strap, and guarantee that the other end of the anti-static
wrist strap is connected to the ESD jack of the chassis. On the
other hand, you should avoid contacting the circuit with your
hands.
Unplug the service board:
a) Unplug the cables from all
interfaces of the card.
b) Unscrew the screws from the
both sides of the card.
c) Pull the extractors on the both
sides of the card, and press them
outward, thus unplugging the card
from
the
connector
backboard of the chassis.
d) Hold the front panel to unplug
the card from the slot completely.
e) Put the replaced card in the
anti-static package.
After unplugging the card, you
should plug a new service board
in the slot of the original service
board in 60 seconds
(see the detailed installation steps
in the hardware installation part).
Generation conditions
Troubleshooting
Inspection (display of the
indicator and screen)
The system indicator flashes
the
normally.
if
of
the
SAGEM 3P@C
Advertisement
Table of Contents
