Command Line System; Command Mode; Common Commands; Table 6-1 Description Of The Read-Only Mode And The Configuration Mode - Sagem 4450E Hardware Installation Manual

6.3. Command Line System

6.3. 6.3. 6.3.
3P@C 4450E adopts the 3P@COS. 3P@COS is the operating system developed specially for its 3P@C series
of products.
Note

6.3.1. Command Mode

6.3.1.
6.3.1. 6.3.1.
There are two command modes for the 3P@C 4450E IP-DSLAM : Read-only mode for ordinary users and
configuration mode for administrators. For descriptions of the two command modes, refer to Table 6-1 .

Table 6-1 Description of the read-only mode and the configuration mode

Command
mode
Read-only
mode
Configuration
mode
The user that logs in the system with default user name "admin" and password "3P@C" is called an
administrator who can configure and operate the switch in both read-only and configuration modes. After the
administrator inputs the correct login username and password, he will first enter the read-only mode. To enter
the configuration mode, he needs to use the enable command and input the password for entering the
configuration mode. The administrator has both the rights to configure the switch and the rights to manage the
users, including creating/deleting users, modifying user rights, modifying login password and the password for
entering configuration mode.
6.3.2.

6.3.2. Common Commands

6.3.2. 6.3.2.
For a preliminary understanding of the usage of the 3P@C 4450E commands, the following introduces the
usage method of some common commands, as shown in Table 6-2 and Table 6-3.

Table 6-2 Commands in the read-only mode

Command
clear
enable
exit
help
list
logout
3P@C Installation Manual
Page 6-4 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
All the commands of the 3P@COS command line are
case insensitive.
Function
View most of the system
information and
configuration information of
the switch
View and configure all the
information of the switch
Function
Clears the screen display
Enters the configuration mode to perform
configuration and write operations on the switch
Exits the current configuration mode and returns
to the previous mode. If executed in the read-only
mode, this command will enable users to exit
from the system.
Shows how to use the syntax help in the
command line
Shows the list of current available commands
Logs out and disconnects
Applicable Command
users prompt
Ordinary 3P@C>
user
Administrator 3P@C(config)#
SAGEM 3P@C