Figure 3-3 Packing Structure Of The Equipment Inside The Packing Box - Sagem 4450E Hardware Installation Manual

Figure 3-3 Packing structure of the equipment inside the packing box

prompt
To unpack the packing box, take the following steps:
Step 1
Step 2
Note
Note
3P@C Installation Manual
Page 3-11 Reproduction and communication in any form prohibited without the written
permission of SAGEM SA
Foam pad
The above figure indicates the structure of the packing box
inside and shows the packing materials such as antistatic
plastic bag and desiccant.
Remove the outside packing materials.
Place the packing box as indicated and use a claw hammer or
screwdriver to remove the plastic clips around the top cover. The
upper cover can be opened.
Remove the equipment packing materials.
Remove the packing materials (e.g. foam pads) on the equipment
and carefully and smoothly draw out the equipment. Remove the
packing plastic bag of the equipment.
If the equipment is moved from a place with low temperature
and low humidity to another place with high temperature and
high humidity, you have to wait at least 30 minutes before
unpacking it so as to avoid damages to the equipment
caused by the moisture condensed on the equipment
surface.
Since the equipment is rather heavy, please operate it
carefully and avoid colliding with human or articles. Raise
and hold rigid places such as the rack base and skeleton to
avoid damaging the equipment or any other accidents.
Paper board
SAGEM 3P@C
Air deflector frame
Fan module
10U chassis
Packing box