Hot Plugging - Sagem 4450E Hardware Installation Manual

Indicator
Table 1-5 Description of the indicator of the ADUB service board
Indicator
Status indicator
of the ADUB
Table 1-6 Description of the indicator of the ADUC service board
Indicator
Status indicator
of the ADUC

9.2.2. Hot Plugging

The device supports the hot plugging of the service board in the normal running, and the original configuration
information is saved in the system in the plugging process. Two situations happen when the user replaces the
service board:
If the type of the subsequently plugged card is the same as that of the unplugged card, the
original configuration information will be recovered automatically.
If the type of the subsequently plugged card is different from that of the unplugged card, the
original configuration information will not be recovered automatically, and the user needs to
configure the new card.
After unplugging the card from a slot, you cannot plug the card immediately, and you should do it in a minute.
Note
3P@C Installation Manual
Page 9-7 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Flag Color Status
ACT Green Flashing
Off
Flag Color Status
RUN Green On
Off
Flashing
ALM Red Off
ON
Flag Color Status
RUN Green On
Off
Flashing
ALM Red Off
ON
During the system startup process, the hot plugging is not
supported.
Description
Data is
received/transmitted
user interface.
No data
received/transmitted
user interface.
Description
Power on the system.
No power on or the system runs
abnormally.
The ADUB runs normally.
The ADUB runs normally.
The ADUB has an alarm.
Description
Power on the system.
No power on or the system runs
abnormally.
The ADUC runs normally.
The ADUC runs normally.
The ADUC has an alarm.
SAGEM 3P@C
being
in the
is
in the