Toshiba e-studio3511, e-studio4511 Manual page 321

[L] ADU clutch
(1) Take off the ADU, ADU inside rear cover, ADU
opening/closing switch, paper guide, and ADU
cover ( Chapter 17.5 [A] to 17.5 [E]).
(2) Take off the ADU motor (
(3) Take off the ADU gear unit
( Chapter 17.5 [K]).
(4) Remove the screw and take off the ground
wire.
(5) Disconnect 1 connector.
(6) Loosen 1 setscrew and take off the ADU
clutch.
[M] Upper transport roller
(1) Take off the ADU, ADU inside rear cover, ADU
opening/closing switch, paper guide, and ADU
cover ( Chapter 17.5 [A] to 17.5 [E]).
(2) Remove 2 screws and take off the opening/
closing lever.
(3) Remove the spring.
November 2003 © TOSHIBA TEC
Chapter 17.5 [J]).
Screw
17 - 15
Ground wire
Screw
Fig. 17-517
Setscrew
ADU clutch
Fig. 17-518
Opening/Closing lever
Fig. 17-519
Fig. 17-520
e-STUDIO3511/4511 AUTOMATIC DUPLEXING UNIT
Connector
Spring
17