Toshiba e-studio3511, e-studio4511 Manual page 164

(13) Loosen 1 setscrew, disconnect 1 connector
and take off the upper transport clutch (high
speed) with the gear.
Note: Do not mix up the registration clutch and
upper transport clutch (high speed) when
installing.
(14) Disconnect 2 connectors and remove 5 screws.
Take off the transport motor drive unit.
9
(15) Remove 2 screws and take off the transport
motor.
(16) Remove 2 screws and take off the bracket,
and then take off the upper transport clutch
(low speed).
(17) Remove 9 screws and take off the cover of
transport gear drive unit.
e-STUDIO3511/4511 DRIVE SYSTEM
Upper transport clutch
(High speed)
Fig. 9-516
Transport motor drive unit
Fig. 9-517
Transport motor
Upper transport clutch (Low speed)
Fig. 9-518
Cover
Fig. 9-519
9 - 12
Setscrew
Connector
Connector
Bracket
November 2003 © TOSHIBA TEC