Toshiba e-studio3511, e-studio4511 Manual page 128

[F] Lens unit
(1) Remove the lens cover (
(2) Disconnect 1 connector and remove 5 screws.
Then remove 2 screws and 2 ground wires and
take off the lens unit.
Notes: 1. When installing the lens unit, fix it while
pushing it to the direction of the white
arrow.
6
2. For adjustment, refer to "3.9.2 Lens Unit"
in the Service Handbook.
3. Do not touch 4 screws shown with the
arrows when replacing the lens unit.
4. Handle the unit with care. Do not touch
the adjusted area and lens. (Hold the unit
as the right figure.)
[G] Scan motor
(1) Take off the upper rear cover ( Chapter 2.5.1
[Q]).
(2) Take off the rear cover ( Chapter 2.5.1 [P]).
(3) Disconnect 1 connector.
e-STUDIO3511/4511 SCANNER
Chapter 6.7 [B]).
[Rear side]
6 - 18
Lens unit
Fig. 6-708
Fig. 6-709
Lens
Adjusted area
Fig. 6-710
Fig. 6-711
November 2003 © TOSHIBA TEC
Ground
wire
[Front side]
Connector
Scan motor