Toshiba e-studio3511, e-studio4511 Manual page 132

[I] Platen sensor
(1) Take off the upper rear cover (
[Q]).
(2) Disconnect 1 connector. Release the latches
and take off the platen sensor.
[J] Carriage home position sensor
(1) Take off the upper rear cover (
[Q]).
6
(2) Disconnect 1 connector. Release the latches
and take off the carriage home position sensor.
[K] Scanning section control PC board
(SLG board)
(1) Take off the lens cover ( Chapter 6.7 [B]).
(2) Disconnect 7 connectors, remove 6 screws and
take off the SLG board.
e-STUDIO3511/4511 SCANNER
Carriage home position sensor
Chapter 2.5.1
Chapter 2.5.1
Platen sensor
SLG board
6 - 22
Fig. 6-723
Fig. 6-724
November 2003 © TOSHIBA TEC