Toshiba e-studio3511, e-studio4511 Manual page 177

[D] Drawer feeding
(D-1) Lower drawer
• The feed clutch and the transport clutch (high speed) are turned ON, and the pickup roller, feed
roller and transport roller are rotated to start feeding paper.
• Passing of the leading edge of the paper turns ON the lower drawer feed sensor, then the transport
clutch (high speed) is turned OFF then back ON.
• Passing of the leading edge of the paper turns ON the registration sensor and the paper is aligned
by the registration roller.
• The transport clutch (high speed) is turned OFF and the transport roller is stopped.
• The registration clutch and transport clutch (low speed) are turned ON and the paper is transported
to the transfer unit.
(D-2) Upper drawer
• The feed clutch and the transport clutch (high speed) are turned ON, and the pickup roller, feed
roller and transport roller are rotated to start feeding paper.
• Passing of the leading edge of the paper turns ON the upper drawer feed sensor, then the feed
clutch and the transport clutch (high speed) are turned OFF then back ON.
• Passing of the leading edge of the paper turns ON the registration sensor and the paper is aligned
by the registration roller.
• The feed clutch and the transport clutch (high speed) is turned OFF and the transport roller is
stopped.
• The registration clutch and transport clutch (low speed) are turned ON and the paper is transported
to the transfer unit.
November 2003 © TOSHIBA TEC 10 - 9 e-STUDIO3511/4511 PAPER FEEDING SYSTEM
10