Toshiba e-studio3511, e-studio4511 Manual page 262

4. If the transfer belt drive gear is not
properly engaged, the hole positions of
the fixing screw (as shown in the figure
at right) may not match. In this case,
operate the main motor for approx. 1
second in the Test Mode (03-101) to
engage the drive gear securely and then
install the unit.
[B] Transfer belt
Note: Wearing gloves is recommended to avoid
direct touch by bare hands to the transfer
belt surface.
(1) Take off the transfer belt unit (
[A]).
(2) Remove 2 clips and take off the shaft by sliding
it to the rear side.
Note: When installing the shaft, insert the narrow
part of the shaft into the stay on the rear side
and fit it into the front side by sliding it.
(3) Remove 1 screw and 2 stand plates.
14
e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT
Chapter 14.7
Stand plate (long)
Stand plate
(short)
14 - 8
04/05
Fig. 14-708
Fig. 14-709
Fig. 14-710
November 2003 © TOSHIBA TEC