Toshiba e-studio3511, e-studio4511 Manual page 188

(2) Remove the lever from the holder and take off
the separation roller along with its shaft.
(3) Take off the cover, arbor, clutch spring, and then
the separation roller from the shaft.
Note: When reassembling the pickup roller, feed
roller and separation roller, pay attention to
the followings:
1. Set the timing belt securely on the pulleys.
2. Pay attention to the "lock" direction of the
one-way clutch.
CLUTCH-6-L
3. Fit the clips securely into the groove on
10
the shaft.
4. Confirm that there is no oil staining etc.
on the surface of the timing belt, pulleys
and rollers.
5. Pay attention to the mounting direction of
the rollers.
6. Lubricate the separation roller on every
replacement. Refer to the Service
Handbook for more details.
(E-4) Pickup roller
(1) Take off the pickup roller from the pickup arm
and remove the belt.
e-STUDIO3511/4511 PAPER FEEDING SYSTEM
LOCK
Fig. 10-437
Holder
Arbor
Spring
Fig. 10-438
Paper
Separation roller
Fig. 10-439
One-way clutch
Pickup roller
Pickup arm
Fig. 10-440
10 - 20
Lever
Cover
Clutch spring
Separation roller
Shaft
Arbor
Spring
Feed roller
Pickup roller
Belt
Pickup arm
November 2003 © TOSHIBA TEC