Toshiba e-studio3511, e-studio4511 Manual page 320

[I] ADU driving PC board (ADU board)
(1) Take off the ADU, ADU inside rear cover, ADU
opening/closing switch, paper guide, and ADU
cover (
(2) Remove the ADU inside rear cover
( Chapter 17.5 [B]).
(3) Remove the ADU cover (
(4) Disconnect 6 connectors and release 4 lock
supports to take off ADU board.
[J] ADU motor
(1) Take off the ADU, ADU inside rear cover, ADU
opening/closing switch, paper guide, and ADU
cover (
(2) Disconnect 1 connector and remove the
binding band.
(3) Remove 2 screws.
(4) Lift the ADU motor slightly and shift it to the
direction of the arrow to take it off.
17
[K] ADU gear unit
(1) Take off the ADU, ADU inside rear cover, ADU
opening/closing switch, paper guide, and ADU
cover (
(2) Take off the ADU motor (
(3) Remove 3 screws and take off the ADU gear
unit.
Note: Match the protrusion of clutch with the
position shown in the figure when
assembling.
e-STUDIO3511/4511 AUTOMATIC DUPLEXING UNIT
Chapter 17.5 [A] to 17.5 [E]).
Chapter 17.5 [E]).
Chapter 17.5 [A] to 17.5 [E]).
Chapter 17.5 [A] to 17.5 [E]).
Chapter 17.5 [J]).
ADU board
Fig. 17-513
Binding band
Connector
Fig. 17-514
ADU motor
Screw
Fig. 17-515
Screw
Fig. 17-516
17 - 14
ADU gear unit
November 2003 © TOSHIBA TEC