Toshiba e-studio3511, e-studio4511 Manual page 295

(4) Remove spring (B) on each end of the oil roller.
(5) Take off the oil roller.
(6) Remove 1 bushing from each side of the oil
roller.
Note: Install the oil roller according to the marking
on the frame (the shaft end with a groove
should point at the rear side).
[C] Cleaning roller
(1) Take off the oil roller from the cleaning unit (
Chapter 16.7 [B]).
(2) Remove 1 E-ring and 1 bushing from the
cleaning roller front side. Then take off the
cleaning roller.
(3) Remove the spring (A) on each end of the
frame.
Note: When installing, make sure that the oil roller
rotates smoothly by turning the gear (C) of
the cleaning roller manually for a several
times.
November 2003 © TOSHIBA TEC
- Front side -
Oil roller
Fig. 16-705
Fig. 16-706
Fig. 16-707
Cleaning roller
E-ring
Bushing
Fig. 16-708
16 - 17 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION
Spring (B)
- Rear side -
Bushing
Groove
Gear (C)
Spring (A)
16