Toshiba e-studio3511, e-studio4511 Manual page 180

(A-2) Bypass tray slide guide width detection
PC board
(1) Release the harness from 1 harness clamp
and disconnect 1 connector.
(2) Remove 2 screws and take off the hinge unit.
(3) Detach the bypass tray from the protrusion at
the fulcrum of the frame.
10
(4) Remove 3 screws and release 4 latches.
Take off the upper cover of the bypass tray.
(5) Remove 1 screw and the plate spring.
(6) Remove 1 screw (indicated with a white arrow)
from the back side, then take off the bracket.
e-STUDIO3511/4511 PAPER FEEDING SYSTEM
Fig. 10-405
Fulcrum
Fig. 10-406
Latch
Fig. 10-407
Bracket
Fig. 10-408
10 - 12
Bypass tray
Bypass tray upper cover
Latch
Plate spring
November 2003 © TOSHIBA TEC