Toshiba e-studio3511, e-studio4511 Manual page 103

No. Message
73 The number of
originals exceeds the
limits.
Will you save stored
originals?
74 Install new Black
toner cartridge
75 Install new Yellow
toner cartridge
76 Install new Magenta
toner cartridge
77 Install new Cyan
toner cartridge
78 Install new Y and M
toner cartridge
79 Install new Y and C
toner cartridge
80 Install new M and C
toner cartridge
81 Install new color
toner cartridge
82 Time for periodic
maintenance
83 READY
(CHANGE DRAWER
TO CORRECT
MEDIA TYPE)
84 PRESS [BASIC]
and select normal
paper size
85 Misfeed in copier
Press [HELP]
86 Call for service
87 Please try again after
a while
88 Set standard size
November 2003 © TOSHIBA TEC
State of equipment
Displayed when confirming the user to save
the scanning data as much as stored at
memory-full state
No black toner in the cartridge
No yellow toner in the cartridge
No magenta toner in the cartridge
No cyan toner in the cartridge
No yellow and magenta toner in the
cartridges
No yellow and cyan toner in the cartridges
No magenta and cyan toner in the cartridges
Three colors of toner are running out in the
cartridges
PM cycle
- Displayed at the time for maintenance
- Copying is available
Displays when the printing is stopped
because of media type mismatch
Displays the warning that the copy is not
enabled when any drawer but bypass feed is
selected at Cover Sheet Mode or Sheet
Insertion Mode.
Paper jam in the equipment
- Displayed when paper jam occurred in the
equipment
Displayed when motor, sensor, switch, etc.
do not work properly
Displayed when the Department Code can
no be keyed in immediately after power-ON.
Displayed when the paper size which is not
acceptable is set (depends on the setting)
5 - 7
Note
Displayed only in Scanning Function
Displayed when black toner is
running out even if other toner still
remain. Copying not enabled
Black copying is available
Other button functions are available
Black copying is available
Other button functions are available
Black copying is available
Other button functions are available
Black copying is available
Other button functions are available
Black copying is available
Other button functions are available
Black copying is available
Other button functions are available
Black copying is available
Other button functions are available
Maintenance and inspection are
performed by qualified service
technician.
Remove the paper in the equipment
according to the messages displayed
on the panel.
Turn OFF the power and solve the
problem, then turn ON the power.
Leave it for a while and key in the
code again
Reset the paper size
e-STUDIO3511/4511 CONTROL PANEL
5