Toshiba e-studio3511, e-studio4511 Manual page 272

(7) Remove 1 screw and the pin. (Front side)
(8) Remove 1 screw and the pin. (Rear side)
(9) Disconnect 1 connector and take off the case.
(10) Remove 1 clip and take off the 2nd transfer
roller contact clutch.
[L] 2nd transfer roller position detection sensor
(1) Take off the 2nd transfer unit
( Chapter 14.7 [J]).
14
(2) Take off the case (
(3) Disconnect 1 connector. Then take off the 2nd
transfer roller position detection sensor.
[M] Paper clinging detection sensor
(1) Take off the transfer belt unit
( Chapter 14.7 [A]).
(2) Open the ADU and 2nd transfer unit.
(3) Remove 1 screw to slide the bracket downward.
Then disconnect 1 connector.
e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT
Chapter 14.7 [K]).
14 - 18
04/05
Pin
Fig. 14-745
Clip
2nd transfer roller
contact clutch
Fig. 14-746
Fig. 14-747
Fig. 14-748
November 2003 © TOSHIBA TEC
Case
Pin
2nd transfer roller
position detection
sensor
Bracket