Toshiba e-studio3511, e-studio4511 Manual page 299

(5) Remove 1 E-ring. Then remove 1 bearing.
(6) Lift up the separation roller by sliding it.
(7) Take off the fuser belt.
Note: When installing the fuser belt, place a sheet
of paper between the separation plate and
fuser belt in order to prevent the fuser belt
from being scratched by the separation plate.
Keep the paper between then until the fuser
roller is installed.
[G] Separation finger
(1) Take off the fuser roller (
(2) Lift up the fuser belt unit and take it off.
Note: Be careful not to scratch the fuser belt. Lay
the fuser belt on the clean place to prevent
the belt from the dust.
November 2003 © TOSHIBA TEC
Paper
Chapter 16.7 [E]).
Fuser belt
16 - 21 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION
E-ring
Bearing
Fig. 16-721
Fuser belt
Separation plate
Separation roller
Fig. 16-722
Fuser belt
Fig. 16-723
Fuser belt unit
Fig. 16-724
16
Separation
plate