Toshiba e-studio3511, e-studio4511 Manual page 268

(8) Remove 3 conductive tapes.
Note: When assembling, use the new conductive
tape. Also, attach the conductive tape to the
transfer belt cleaning blade referring to the
figure on the right.
(9) Remove 2 screws and take off the transfer belt
cleaning blade.
Notes: 1. Make sure not to touch or damage the
14
edge of the blade.
2. Check the color deviation after replacing
the transfer belt cleaning blade.
[H] Transfer belt cleaner auger motor /
Transfer belt cleaner clutch
(1) Take off the transfer belt cleaning unit
( Chapter 14.7 [F]).
(2) Separate the transfer belt cleaning unit into
2 parts.
( Chapter 14.7 [G]).
(3) Release the latch and take off the gear.
e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT
Conductive tape
Fig. 14-729
47 mm
Fig. 14-730
Cleaning blade
Fig. 14-731
Gear
Fig. 14-732
14 - 14
04/10
160 mm
41 mm
November 2003 © TOSHIBA TEC