Toshiba e-studio3511, e-studio4511 Manual page 100

No. Message
20 READY
(SADDLE STITCH
TRAY FULL)
21 READY
(CHANGE DRAWER
TO CORRECT
PAPER SIZE)
22 Ready for bypass
5 feeding
23 COPYING
24 Auto Start
25 Close Large Capacity
Feeder
26 Close Large Capacity
Feeder Door
27 Place Doc. Feeder in
the down position
28 Insert key copy
counter
29 Place originals in the
document feeder
30 Change direction of
original
31 Place last %d
originals in doc.
feeder entrance tray
32 Cannot copy this
original
33 Add paper
34 Cannot duplex this
size
35 Cannot use this
media type
36 Copy size: A4/LT
only
37 Copy size: A4/LT and
A4-R/LT-R
38 CHANGE DRAWER
TO CORRECT
PAPER SIZE
39 Change drawer to
correct media type
e-STUDIO3511/4511 CONTROL PANEL
State of equipment
Saddle stitcher tray is full of paper
- Scanning is enabled
Incorrect paper size setting
Paper is set on the bypass tray
At the copying state
Auto Start is set during printing
LCF drawer is not installed when feeding
from LCF is set
LCF cover is open when feeding from LCF is
set
RADF is open when original is placed on
RADF
Key copy counter not inserted
Displayed when the conditions are set and
START button is pressed with no original
placed
Displayed when the direction of original
placed is different from the setting
Paper jam occurred during copying (RADF
scanning)
Displayed when the original which is not
allowed to be copied is placed
Displayed when the paper in selected drawer
is running out
Displayed when the paper size which is not
specified for duplex copying is set
Displayed when the paper size which is not
specified for the functions such as stapling or
hole punching is set
Displayed when the paper size which is not
specified for "Book-type duplex copying" or
"Dual-page" is set
Displayed when the paper size which is not
specified for "Rotate Sort"
Displayed when the selected paper size is
not in the drawer
Displayed when the selected media type is
not in the drawer
5 - 4
Note
Cleared by pressing [RESET] button
or [STOP] button
Cleared by installing LCF drawer
Cleared by closing the cover
Cleared by closing RADF
Cleared by inserting key copy
counter
Cleared by setting the original
Not printed out
November 2003 © TOSHIBA TEC