Try Out The Sounds; Turning On The Power - Roland V-Card VC-1 Owner's Manual

Try Out the Sounds

Turning On the Power

To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and
turn off the power on all devices before making any connections.
fig.12-03e(ConnectionImage)
1.
Before hooking anything up, make sure that the power on all of
your gear is turned OFF.
2.
Connect the VariOS to your amp/speaker system.
3.
After correctly inserting the VC-1 into the PC card slot in the
VariOS's front panel, switch ON the POWER switch.
* Carefully insert the PC card all the way in – -until it is firmly in place.
* This unit is equipped with a protection circuit. A brief interval (a few
seconds) after power up is required before the unit will operate normally.
* Always make sure to have the volume level turned down before switching
on power. Even with the volume all the way down, you may still hear
some sound when the power is switched on, but this is normal, and does
not indicate a malfunction.
* Never insert or pull out while the VC-1 (VariOS) is turned on.
4.
Turn on the power for any connected amplifiers or speakers.
5.
Wait for the VC-1 to start up. When it has started up normally, a screen like the following will appear. The
display shows the selected Patch.
fig.12-04e(Card&LCD_default)
94
MIDI IN
MIDI OUT
MIDI Keyboard
Patch Number Cursor
Patch Name
Monitor Speaker