Roland V-Card VC-1 Owner's Manual page 141

■Channel Mode Messages
●All Sounds Off (Controller number 120) (for VariOS only)
Status 2nd byte
BnH 78H
n = MIDI channel number: 0H - FH (ch.1 - 16)
● Reset All Controllers (Controller number 121) (for VariOS only)
Status 2nd byte
BnH 79H
n = MIDI channel number: 0H - FH (ch.1 - 16)
●OMNI OFF (Controller number 124) (for V-Synth only)
Status 2nd byte
BnH 7CH
n = MIDI channel number: 0H - FH (ch.1 - 16)
●POLY (Controller number 127) (for V-Synth only)
Status 2nd byte
BnH 7FH
n = MIDI channel number: 0H - FH (ch.1 - 16)
■System Realtime Messages
●Active Sensing
Status
FEH
* This message is transmitted at intervals of approximately 250 msec.
●System Exclusive Messages
Status
F0H :System Exclusive
F7H :EOX (End Of Exclusive)
Transmitted in the following three cases.
1. When Operating Bulk-Dump
2. If Exclusive of System MIDI is "P-Dump," this unit transmits all parameters
in the patch when the patch is changed.
3. If Exclusive of System MIDI is "TxEdit," this unit transmits the parameter
when the parameter is edited.
Refer to Section 3 to see details.
3rd byte
00H
3rd byte
00H
3rd byte
00H
3rd byte
00H
2. Receive data
■Channel Voice Messages
●Note off
Status 2nd byte
8nH kkH
9nH kkH
n = MIDI channel number:
kk = note number:
vv = note off velocity:
●Note on
Status 2nd byte
9nH kkH
n = MIDI channel number:
kk = note number:
vv = note on velocity:
●Control Change
m Bank Select (Controller number 0, 32)
Status 2nd byte
BnH 00H
BnH 20H
n = MIDI channel number:
mm, ll = Bank number:
* Not received when the Bank Select Switch (SYSTEM MIDI) is OFF.
* The Patches corresponding to each Bank Select are as follows.
BANK
SELECT
PROGRAM
MSB LSB
NUMBER
000 001 - 064
001 001 - 064
002 001 - 064
003 001 - 064
004 001 - 064
005 001 - 064
006 001 - 064
087
007 001 - 064
008 001 - 064
009 001 - 064
010 001 - 064
011 001 - 064
012 001 - 064
013 001 - 064
* The MSB value to be transmitted can be set individually for
* each patch using Tx Bank Select (PATCH MIDI).
* In this case, "0" is always output for the LSB.
❍Modulation (Controller number 1)
Status 2nd byte
BnH 01H
n = MIDI channel number:
vv = Modulation depth:
MIDI Implementation
3rd byte
vvH
00H
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
00H - 7FH (0 - 127)
3rd byte
vvH
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
01H - 7FH (1 - 127)
3rd byte
mmH
llH
0H - FH (ch.1 - 16)
00 00H - 7F 7FH (bank.1 - bank.16384)
BATCH PATCH
BANK NUMBER
Internal 1 11 - 88
Internal 2 11 - 88
Internal 3 11 - 88
Internal 4 11 - 88
Internal 5 11 - 88
Internal 6 11 - 88
Internal 7 11 - 88
Internal 8 11 - 88
Preset 1 11 - 88
Preset 2 11 - 88
Preset 3 11 - 88
Preset 4 11 - 88
Preset 5 11 - 88
Preset 6 11 - 88
3rd byte
vvH
0H - FH (ch.1 - 16)
00H - 7FH (0 - 127)
141