Connecting The V-Synth To Your Computer Via Usb - Roland V-Card VC-1 Owner's Manual

Connecting to Your Computer via USB
fig.11-03(System_UsbSetup)
7.
Touch USB Mode <Storage>. USB Storage mode will be selected.
8.
Touch <OK>.
fig.11-04(Warning)
9.
When a WARNING window like the following appears, touch
<ACCEPT> to close the window.
10. In the lower right of the SYSTEM Com MIDI/USB screen, touch
<Write> to save the system settings.

Connecting the V-Synth to Your Computer via USB

The installation procedure will differ depending on your system. Please proceed to one of the following
sections, depending on the system you use.
• Windows XP/2000/Me/98 (p. 84)
• Macintosh (p. 85)
Windows XP/2000/Me/98
fig.11-05(ModeMenuUsb)
1.
Make sure that the power of the VC-1 is turned off.
2.
Start up your computer.
3.
Connect the V-Synth and your computer using a USB cable.
4.
Turn on the power of V-Synth.
5.
Insert the VC-1 into the PC CARD slot of the V-Synth rear panel.
6.
Press [MODE] to access the V-Synth MODE MENU window.
7.
Touch <USB>. The USB Storage screen appears.
84