Transferring Patches from the D-50/550 to the VC-1
* You cannot bulk load data when a patch in the Preset Banks (Pre1 – Pre6) is selected.
* The VC-1 display does not change immediately following the bulk load. This is due to the fact that the work area is
the bulk load destination (p. 107). You can confirm the outcome of the transfer by switching patches with the
VALUE dial.
Using the D-50
1.
Use a MIDI cable to connect the D-50's MIDI OUT connector to the VariOS's MIDI IN connector.
2.
Set the D-50 and VariOS to the same MIDI channel (the basic channel; p. 117).
3.
Turn the MIDI Mode of the VariOS to Internal (p. 119)
4.
Press the D-50's [DATA TRANSFER] button.
5.
While pressing the D-50's [DATA TRANSFER] button, specify "B.Dump)" with Selector button.
6.
Press the D-50's [ENTER] button to begin the bulk dump. When the data transfer is completed, the D-50's
display shows "Complete."
7.
Press the [EXIT] button on the D-50 to return to the play mode.
Using the D-550
1.
Use a MIDI cable to connect the D-550's MIDI OUT connector to the VariOS's MIDI IN connector.
2.
Set the D-550 and VariOS to the same MIDI channel (the basic channel; p. 117).
3.
Turn the MIDI Mode of the VariOS to Internal (p. 119)
4.
Press the D-550's [DATA TRANS] button.
5.
Select "(B.Dump)" with the D-550's [
6.
Hold down the D-550's [DATA TRANS] button and press the D-550's [ENTER] button to begin the bulk
dump. When the data transfer is completed, the D-550's display shows "Complete."
7.
Press the [EXIT] button on the D-550 to return to the play mode.
Transferring Patches To and From the D-50/550
4, 5
7
5
7
6
] or [
] button.
6
4, 6
103