Transferring Patches From The Vc-1 To The D-50/550 - Roland V-Card VC-1 Owner's Manual

Transferring Patches To and From the D-50/550

Transferring Patches from the VC-1 to the D-50/550

Using the D-50
3-1
1.
Use a MIDI cable to connect the V-Synth's MIDI OUT connector to the D-50's MIDI IN connector.
2.
Set the D-50 and V-Synth to the same MIDI channel (the basic channel; p. 80).
3.
Turn the Memory Protect of the D-50 to OFF.
3-1.
Press the [TUNE/FUNCTION] button.
3-2.
Select "Protect" with the Selector button and turn it OFF with the joystick.
4.
Enable reception of bulk load data on the D-50.
4-1.
Press the D-50's [DATA TRANSFER] button.
4-2.
While pressing the D-50's [DATA TRANSFER] button, specify (B.Load) with the Selector
button.
4-3.
Press the D-50's ENTER] button.
fig.04-05a
5.
Turn the Exclusive Sw of the V-Synth to On.
5-1.
Press [MODE].
5-2.
Touch <SYSTEM>.
5-3.
Select "Exclusive Sw," then turn the V-Synth's VALUE
dial to specify On.
6.
Press [MODE] on the V-Synth. The MODE MENU window appears.
7.
Touch <DATA TRANSFER>. The DATA TRANSFER screen
appears.
fig.04-06(LCD_DataTrans_BulkDump)
8.
Touch <B.Dump> in the left of the screen. The MIDI Bulk Dump
screen appears.
9.
Modify the value by either turning the VALUE dial or pressing
[INC/+] or [DEC/-].
Source Bank
Selects the Patch Bank in the VC-1 with the patch data to transfer
to the D-50.
Value: I1 – I8, P1 – P6
10. Touch <OK>. The bulk dump starts. If you want to cancel without
executing, touch <Cancel>.
11. When the data transfer is completed, the D-50's display shows "Complete."
12. Press the [EXIT] button on the D-50 to return to the play mode.
40
3-2 4-1, 4-2 12 4-3