Orientation To Inverter Features - Hitachi SJ7002 Series Instruction Manual

2–2

Orientation to Inverter Features

Orientation to Inverter Features

Unpacking and
Inspection
Main Physical
Features
Please take a few moments to unpack your new SJ700
1. Look for any damage that may have occurred during shipping.
2. Verify the contents of the box include:
a. One SJ700 inverter
2
b. One Instruction Manual (supplied by printed book for –FU2/–FF2 models, supplied on
CR-ROM for –FE2 models)
c. One SJ700 Quick Reference Guide
2
d. One packet of desiccant—discard (not for human consumption)
3. Inspect the specifications label on the front or side of the inverter. Make sure it matches the
product part number you ordered.
The SJ700 Series inverters vary in size according to the current output rating and motor size
2
for each model number. All feature the same basic keypad and connector interface for
consistent ease of use. The inverter construction has a heat sink at the back of the housing. The
fans enhance heat sink performance. Mounting holes are pre-drilled in the heat sink for your
convenience. Never touch the heat sink during or just after operation; it can be very hot.
The electronics housing and front panel are built onto the front of the heat sink. The front panel
has three levels of physical access designed for convenience and safety:
• First-level access – for basic use of inverter and editing parameters during powered
operation (power is ON)
• Second-level access – for wiring the inverter power supply or motor (power is OFF)
• Third-level access – for accessing the expansion bay for adding/removing expansion boards
(power is OFF)
1. First-level Access - View the unit just as it
came from the box as shown. The
OPE-SRE or OPE-S digital operator
keypad comes installed in the inverter. The
four-digit display can show a variety of
performance parameters. LEDs indicate
whether the display units are Hertz, Volts,
Amperes, or kW. Other LEDs indicate
Power (external), and Run/Stop Mode and
Program/Monitor Mode status. Membrane
keys Run and Stop/Reset, and a Min/Max
frequency control knob (OPE-SRE only)
control motor operation. These controls
and indicators are usually the only ones
needed after the inverter installation is
complete.
2
The FUNC., , , and STR keys
1
allow an operator to change the inverter's
functions and parameter values, or to select
the one monitored on the 4-digit display.
Note that some parameters may not be
edited if the inverter is in Run mode.
inverter and perform these steps:
2