Extreme Networks Summit WM Maintenance Manual page 81

3 To enable the poll timer, uncheck the Disable Poll Timer checkbox in the Health Checking section.
4 Click Apply.
To enable and define parameters for Syslog:
1 From the main menu, click Summit WM Controller. The Summit WM Controller page is displayed.
2 In the Syslog section, to enable the Syslog function for up to three syslog servers, select the
appropriate checkboxes.
3 For each enabled syslog server, in the IP box, type a valid IP address for the server on the network.
4 For each enabled syslog server, in the Port # box, type a valid port number to connect on. The
default port for syslog is 514.
5 To include all system messages, select the Include all service messages checkbox. If the box is not
selected, only component messages (logs and traces) are relayed. This setting applies to all three
servers. The additional service messages are:
DHCP messages reporting users receiving IP addresses
●
Startup Manager Task messages reporting component startup and failure
●
6 To include audit messages, select the Include audit messages checkbox.
7 From the Application Logs drop-down list, select the log level (local.0 - local.6) to be sent to the
syslog server. This setting applies all three servers.
8 If the Include all service messages checkbox is selected, the Service Logs drop-down list becomes
selectable. Select the log level (local.0 - local.6) to be sent to the syslog server. This setting applies all
three servers.
9 If you selected the Include audit messages checkbox, the Audit Logs drop-down list becomes
available. Select the log level (local.0 - local.6) to be sent to the syslog server. This setting applies all
three servers.
10 To apply your changes, click Apply.
Summit WM Maintenance Guide, Software Version 5.3
81