Extreme Networks Summit WM Maintenance Manual page 106

Summit WM Controller's utilities
NOTE
If you are using any of the following Summit WM Controllers, you must skip Step 4.
• Summit WM100 Controller
• Summit WM1000 Controller
4 In the Publish AP as interface of controller drop-down list, click whether to enable or disable
publishing the Altitude AP and their interfaces as interfaces of the Summit WM Controller. By
default this option is enabled.
When this option is enabled, all Altitude APs and their interfaces are published as interfaces of the
Summit WM Controller when you retrieve topology statistics and configuration information using
the SNMP protocol.
Topology statistics and configuration information on Altitude APs are retrievable using both
proprietary and standard MIB. The Publish AP as interface of controller option only affects
information retrieved through standard MIB, i.e. IF-MIB, RFC1213. All information that is retrieved
through proprietary MIB is not affected. If the Publish AP as interface of controller option is
disabled, the Altitude APs' interfaces are not considered interfaces of the Summit WM Controller.
For example, if the Publish AP as interface of controller option is disabled, querying the ifTable
would return information on the Summit WM Controller physical interfaces, plus all WM-ADs that
are configured on that controller. If enabled, querying the same table would return the above
information, in addition to information on each Altitude APs' interfaces.
NOTE
The Publish AP as interface of controller feature is supported only by the following Summit WM Controller:
• Summit WM200/2000 Controller
• Summit WM20 Controller
5 To save your changes, click Save.
106
Summit WM Maintenance Guide, Software Version 5.3