Extreme Networks Summit WM Maintenance Manual page 125

3 Click the Controlled Upgrade tab.
NOTE
The Controlled Upgrade tab will appear only when the Upgrade Behavior is set to Upgrade when AP connects using
settings from Controlled Upgrade on the WAP Software Maintenance tab.
4 In the Select WAP Platform drop-down list, click the type of AP you want to upgrade.
5 In the Select an image to use drop-down list, click the software image you want to use for the
upgrade.
6 In the list of registered Altitude APs, select the checkbox for each Altitude AP to be upgraded with
the selected software image.
7 Click Apply WAP image version. The selected software image is displayed in the Upgrade To
column of the list.
8 To save the software upgrade strategy to be run later, click Save for later.
9 To run the software upgrade immediately, click Upgrade Now. The selected Altitude AP reboots, and
the new software version is loaded.
NOTE
The Always upgrade WAP to default image checkbox on the WAP Software Maintenance tab overrides the Controlled
Upgrade settings.
Summit WM Maintenance Guide, Software Version 5.3
125