Summit Wm20 Controller Power And Maintenance Procedures - Extreme Networks Summit WM Maintenance Manual

Maintaining the Summit WM Controller
Summit WM20 Controller LEDs
The Summit WM20 Controller has four lights on its front panel. For more information, see the Summit
WM User Guide.
Maintenance:
If a WM20 develops a problem, you should ship it to Extreme Networks.
WARNING!
Properly shut down the system before shipping the Summit WM20 Controller. The sequential steps to power off the
Summit WM20 Controller are similar to powering off the Summit WM200/2000 Controller. For more information, see
"Powering off the Summit WM200/2000 Controller" on page
Backing up the Summit WM20 Controller system configuration:
You can backup the Summit WM20 Controller's system configuration. You can also define the automatic
schedule backups to occur. While defining a scheduled backup, you can configure to have the backup
copied to an FTP server. The backup will be copied to the FTP server after the backup is completed on
the local drive. For more information, refer to the Summit WM User Guide.
WARNING!
Whenever you change the system configuration, you must always define the automatic schedule backup to be copied
to the FTP server. If this not done, you may not able to retrieve the system configuration in the event of HDD
failure.

Summit WM20 Controller power and maintenance procedures

The power and maintenance procedures for the Summit WM20 Controller is similar to the Summit
WM200/2000 Controller. For more information, see
on page 120.
122
120.
"Powering off the Summit WM200/2000 Controller"
Summit WM Maintenance Guide, Software Version 5.3