Restoring V5R1 Image From V5R3 On The Summit Wm20 Controller - Extreme Networks Summit WM Maintenance Manual

9) Reboot
WARNING! - Forcing system recovery will erase all files, and reinstall the image
installed at the factory.
Reboot will restart the system back into Normal mode.
If you have any questions about these options, please contact Support.
Your choice>
10 Enter 7. The following message is displayed.
Your choice: 7
Make sure correct information is entered for Interface and FTP settings.
IP: 192.168.4.191 netmask 255.255.255.0 gateway:
FTP Settings: IP 192.168.4.181, port 21, user: administrator, password: abc123,
directory: /tester/v5r1/, file backup.tgz
This procedure is irreversible, do you wish to continue (Y/N)?
11 Enter Y
After the reboot, the system restores the backed-up image with its original configuration.
Restoring V5R1 image from V5R3 on the Summit WM20
Controller
The procedure for restoring V5R1 on the Summit WM100/1000 Controller is same as described in
"Restoring V4R2 image from V5R3 on the Summit WM20 Controller" on page
Summit WM Maintenance Guide, Software Version 5.3
69.
71