Extreme Networks Summit WM Maintenance Manual page 10

Backing up the existing image
NOTE
To enter the Rescue mode, you must connect to the serial port. You can not enter the Rescue mode by
connecting to the ESA ports, or management/ETH0 port.
b Reboot the Summit WM Controller. The following menu appears during the reboot process.
----------------------------------------------------------------
0: Main Mode
1: Rescue Mode
----------------------------------------------------------------
c Press 1 to enter the Rescue mode. The following Rescue Menu is displayed.
1) Force system recovery
2) Configure interface
3) Configure ftp settings
4) Network settings Menu
5) FTP settings Menu
6) Create backup
7) Reboot
WARNING! - Forcing system recovery will erase all files, and reinstall the image
installed at the factory.
Reboot will restart the system back into Normal mode.
If you have any questions about these options, please contact Support.
Your choice>
2 Configure the interface.
To configure the interface:
a In the Rescue mode, press 2, and then enter the following:
IP address of the controller's Management Ethernet Port
■
IP mask
■
IP address of gateway
■
Your choice> 2
Please enter Interface information
Format <ip>:<netmask> <gw optional>
Input: 192.168.1.201:255.255.255.0 192.168.1.1
Configuring interface ...
Setting up network interface ...Done!
The system configures the interface and returns to the main menu.
3 Configure the FTP settings.
To configure the FTP settings:
a In the Rescue mode, press 3 to configure the FTP settings. The following message is displayed:
Please enter ftp info:
b Type the following string, specifying the following:
User Name for your FTP Server. In the following example, the user name ftpadmin is used.
■
Password
■
IP address
■
Directory path and the file name. The following is the example of the string.
■
ftp://ftpadmin:passwd@192.168.3.10:21//builds/ac/mainBackup/backup.tgz
10
Summit WM Maintenance Guide, Software Version 5.3