Extreme Networks Summit WM Maintenance Manual page 77

h Click Yes. The system reboots and the driver is installed.
5 Connect your laptop to the Summit WM20 Controller via USB A/B Device Cable as shown in
Figure 6.
6 Determine the actual Communications Port # assigned to the device.
To determine the actual Communications Port # assigned to the device:
a On the Start menu, point to Control Panel, point to System, point to Hardware, point to Device
Manager, and then click Ports (Comm &LPT).
b Check the Communications Port number assigned to the device.
7 Establish the connection between your laptop and the Summit WM20 Controller.
To establish the connection:
a Point to All Programs, point to Accessories, point to Communication, and then click terminal
program of your choice (for example, Hyperterminal). The Connect to window opens.
b From the Connect using drop-down menu, select the communications port # assigned to the
device, and then click OK. The Port Settings window opens.
c In the Port Settings window, configure the following settings, and then click OK. The connection
is established.
Speed – 9600
■
Databits – 8
■
Parity – None
■
Stop Bits – 1
■
Flow Control – None
■
Summit WM Maintenance Guide, Software Version 5.3
77