Restoring The Image Directly From The Ftp Server Without Downloading It - Extreme Networks Summit WM Maintenance Manual

NOTE
Download times are usually much faster than upload times.
2 Follow Steps 1 to 4 of
Controller" on page 63
Restoring the image directly from the FTP server without
downloading it
To restore the image directly from the FTP server without downloading it:
1 Return to the main menu.
Rescue AC Start-up Menu. Use with extreme caution.
1) Force system recovery
2) Create System Backup Image
3) Display Backup Images
4) FTP Menu
5) Network Interface Menu
6) Manually run File System Check Utility (fsck)
7) Restore Backup Image Directly From The FTP Server
9) Reboot
WARNING! - Forcing system recovery will erase all files, and reinstall the image
installed at the factory.
Reboot will restart the system back into Normal mode.
If you have any questions about these options, please contact Support.
Your choice>
2 Enter 5. The following menu is displayed.
1) Display Current Rescue Interface Info
2) Enter Interface Information
3) Change ip address
4) Change ip mask
5) Change default gateway
6) Test interface by ICMP (ping)
7) Return to the main menu Connect to the console, using the serial port of
the Controller.
a In the Rescue mode, press 2. The following message is displayed.
Your choice> 2
Please enter Interface information
Format <ip>:<netmask> <gw optional>
b Enter the following information:
IP address of your controller's Management Ethernet Port
■
IP mask
■
IP address of Gateway
■
The system configures the interface and returns to the main menu.
Input: 192.168.1.201:255.255.255.0 192.168.1.1
Configuring interface ...
Setting up network interface ...Done!
Summit WM Maintenance Guide, Software Version 5.3
"Restoring V4R1 GP7 image from V5R3 on the Summit WM100/1000
67