Extreme Networks Summit WM Maintenance Manual page 60

Restoring the backed-up image
To restore the V4R1 GP7 image from V5R1 on the Summit WM200/2000 Controller:
1 Enter the Rescue mode.
To enter the Rescue mode:
a Use the serial port of the Summit WM200/2000 Controller to connect to the console.
NOTE
To enter the Rescue mode, you must connect to the serial port. You can not enter the Rescue mode by
connecting to the ESA ports.
b Reboot the Summit WM Controller. The following menu appears during the reboot process.
----------------------------------------------------------------
0: Main Mode
1: Rescue Mode
----------------------------------------------------------------
c Press 1 to enter the Rescue mode. The following Rescue Menu is displayed.
1) Force system recovery
2) Configure interface
3) Configure ftp settings
4) Network settings Menu
5) FTP settings Menu
6) Create backup
7) Flash menu
9) Reboot
WARNING! - Forcing system recovery will erase all files, and reinstall the image
installed at the factory.
Reboot will restart the system back into Normal mode.
If you have any questions about these options, please contact Support.
Your choice>
2 Configure the interface.
To configure the interface:
a In the Rescue mode, press 2, and then enter the following:
IP address of your WM200/2000 Controller's Management Ethernet Port
■
IP mask
■
IP address of Gateway
■
Your choice> 2
Please enter Interface information
Format <ip>:<netmask> <gw optional>
Input: 192.168.1.201:255.255.255.0 192.168.1.1
Configuring interface ...
Setting up network interface ...Done!
The system configures the interface and returns to the main menu.
3 Configure the FTP settings.
To configure the FTP settings:
a In the Rescue mode, press 3. The following message is displayed.
Please enter ftp info:
60
Summit WM Maintenance Guide, Software Version 5.3