FARGO electronics HDP5000 single-side User Manual page 98

RESTRICTED USE ONLY
Troubleshooting with the LCD Error Message Table (continued)
LCD Error Message
Laminate 1 Jam
(PC Error Message
No. 229)
Laminate 1 Low
(PC Error Message
Nos. 239)
Laminate 1 Out
(PC Error Message
No. 208)
Laminate 2 Bad
(PC Error Message
No. 260 and 262)
Laminate 2 Jam
(PC Error Message
No. 230)
Laminate 2 Low
(PC Error Message
No. 240)
Laminate 2 Out
(PC Error Message
No. 209)
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Cause
A Jam occurred with the
Laminator material in
Cartridge 1.
The material is getting low in
Lamination Cartridge 1.
The Laminate in Cartridge 1
has run out.
The Lamination material in
Cartridge 2 is not valid for
this Laminator.
A Jam occurred with the
Laminator material in
Cartridge 2.
The material is getting low in
Lamination Cartridge 2.
The Laminate in Cartridge 2
has run out.
Fargo Electronics, Inc.
Solution
Open Lam cover and clear the
obstruction
Make sure more is on hand for
when it runs out.
Replace it with a new roll of
material.
Install valid material.
Open Lam cover and clear the
obstruction.
Make sure more is on hand for
when it runs out.
Replace it with a new roll of
material.
5-14