FARGO electronics HDP5000 single-side User Manual page 96

RESTRICTED USE ONLY
Troubleshooting with the LCD Error Message Table (continued)
LCD Error Message
Lam Card Jam
(PC Error Message
No. 53, 212, 214, and
215)
Lam Check Card
(PC Error Message
No. 213)
Lam Com Error
(PC Error Message
No. 246)
Lam Error
(PC Error Message
Nos. 237 and 238)52
Lam Card Not
Ejected
(PC Error Message
No. 216)
Lam Handler Startup
Error
(PC Error Message
No. 66)
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Cause
A jam occurred somewhere
between the Printer and the
Laminator.
A jam occurred inside the
Laminator.
There was a communication
failure between the Printer
and Laminator.
A generic unknown error as
occurred.
The card is not ejected from
the Laminator.
A problem was detected
during Printer start-up.
Fargo Electronics, Inc.
Solution
Open covers and clear the
obstruction/jam.
Open Lam cover and clear the
obstruction.
Check Lam power/connections
and restart the Printer.
Reset the Printer and try
again. If this problem persists,
call for technical assistance.
The Lamination material is
stuck to the card.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
5-12