FARGO electronics HDP5000 single-side User Manual page 94

RESTRICTED USE ONLY
Troubleshooting with the LCD Error Message Table (continued)
LCD Error Message
Head Resistance
(PC Error Message
No. 6)
Head Sensor Error
(PC Error Message
No. 8)
Head Voltage Err
(PC Error Message
Nos. 103 and 105)
Headlift Error
(PC Error Message
Nos. 102, 103, 104,
and 105)
Heater Error
(PC Error Message
No. 161)
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Cause
The EE setting in Driver for
head resistance is out of
range.
The Printhead Temperature
Sensor is not functioning or
is not connected properly.
OR
The Printhead is not cooling
properly.
A hardware fault has
prevented setting the correct
Printhead voltage.
This is a problem with the
Printhead Lift or Transfer
Roller Headlift.
The Transfer Heater Roller is
too hot.
Fargo Electronics, Inc.
Solution
Enter a value for head
resistance in the EE settings in
the Driver.
Reset the correct value
according to the steps in the
Troubleshooting Section.
If this problem persists, call for
technical assistance.
If the problem persists, call for
technical assistance.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
5-10