Technical Specification - Ethernet Option - FARGO electronics HDP5000 single-side User Manual

RESTRICTED USE ONLY

Technical Specification - Ethernet Option

Here are the system requirements for Ethernet.
Caution: For safety purposes, Ethernet is not intended for a direct connection
outside of the building.
Function Requirement
Network An IEEE 802.3 10/100 Base-T Ethernet network is required.
Printer A Fargo Printer with the Ethernet option installed is required.
Printer Since TCP/IP is used for the network communication, the Printer
Configuration must be configured with an IP address and a subnet mask (before it
can be seen on the network).
An additional network setting for the Default Gateway can also be
configured, which allows communication across the subnets.
Host Computer A PC running Windows 2000, Windows XP, Windows 2003.
(connected to the network) is required.
Host Printer The host PC must have installed the correct Printer Driver with
Driver Ethernet support. (Note: This Driver must be configured for printing
to the IP address of the Printer.)
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Fargo Electronics, Inc.
6-2