Section 3: Installation Procedures; Safety Messages (Review Carefully) - FARGO electronics HDP5000 single-side User Manual

RESTRICTED USE ONLY

Section 3: Installation Procedures

Safety Messages (review carefully)

Symbol Critical Procedures for Safety purposes
Danger: Failure to follow these installation guidelines can result in death or
serious injury.
Information that raises potential safety issues is indicated by a warning
symbol (as shown to the left).
•
To prevent personal injury, refer to the following safety messages
before performing an operation preceded by this symbol.
•
To prevent personal injury, always remove the power cord prior to
performing repair procedures, unless otherwise specified.
Caution: This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is indicated by
a warning symbol (as shown to the left).
•
To prevent equipment or media damage, refer to the following
safety messages before performing an operation preceded by this
symbol.
•
To prevent equipment or media damage, observe all established
Electrostatic Discharge (ESD) procedures while handling cables in or
near the Circuit Board and Printhead Assemblies.
•
To prevent equipment or media damage, always wear an
appropriate personal grounding device (e.g., a high quality wrist strap
grounded to avoid potential damage).
•
To prevent equipment or media damage, always remove the
Ribbon and Cards from the Printer before making any repairs, unless
otherwise specified.
•
To prevent equipment or media damage, take jewelry off of fingers
and hands, as well as thoroughly clean hands to remove oil and
debris before working on the Printer.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Fargo Electronics, Inc.
3-1