Table of Contents
Advertisement
RESTRICTED USE ONLY
Using the Print Top of Form Option
Follow these instructions:
Step
Procedure
1
Verify the Transfer TOF is set to +35.
2
Verify the Print TOF is set to +20.
3
Verify the Print LOF is set to +7.
4
Print the alignment card self-test (The front edge should look like Figure
below).
5
Determine which grid line to the left of the center Transfer Alignment Block is
closest to the edge of transfer.
6
Align the leading edge of the center Transfer Alignment Block with the Edge of
Transfer.
• To do this adjust the Print TOF setting up or down by the number located
directly to the right of the line found in the previous step.
• To help with this setting there are (+/-) orientation arrows located at the
upper and lower left sections of the card.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.3)
Fargo Electronics, Inc.
9-16
Advertisement
Table of Contents
Troubleshooting
