Troubleshooting With The Lcd Error Message Table - FARGO electronics HDP5000 single-side User Manual

RESTRICTED USE ONLY

Troubleshooting with the LCD Error Message Table

LCD Error Message
Calibrate Failed
(PC Error Message
No. 155 and 170)
Calibrate Film
(PC Error Message
No. 159)
Calibrate Ribbon
(PC Error Message
Nos. 128 and 170)
Card Feed Stop
(PC Error Message
No. 137)
Card Jam
(PC Error Message
Nos. 82, 112, and
200)
Card Jam: Prox
(PC Error Message
No. 86)
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Cause
Film or Ribbon calibration
has failed.
Film Sensors need to be
calibrated.
The print Ribbon Sensor is
out of calibration.
The Front Cover was
opened. This caused the
card transfer to stop OR the
pause button was selected.
A card is jammed in the Print
Station or card flipping area
of the Printer.
A card is jammed in the
PROX card encoding area of
the Printer.
Fargo Electronics, Inc.
Solution
Verify the film is installed
correctly and there is not a
Ribbon installed. If this
problem persists, call for
technical assistance.
Select Cancel and then
perform the Film calibration
procedure.
Select Cancel and then
perform the Ribbon calibration
procedure.
Press Resume or Cancel.
Clear the jam.
Clear the jam.
5-5