Loading The Overlaminate - FARGO electronics HDP5000 single-side User Manual

RESTRICTED USE ONLY

Loading the Overlaminate

(Note: This procedure only applies to the HDP5000-LC.)
The loading process for both the Thermal Transfer Overlaminate and the PolyGuard™
Overlaminate material is the same. Refer to the following steps to load either type of
overlaminate into the Printer.
Step Procedure
1 Remove the overlaminate from its packaging.
2 Load the Lamination Rolls into the Cartridges until they click.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
Fargo Electronics, Inc.
3-15